Product Overview
JAW PULLUP GRIPS TM
100% Hand Made in Australia
These grips were designed by the founder of JAW. Having been an avid crossfitter for years, the use of tape and other leather grips just weren't doing the trick when it came to constant ripping and tearing, not to mention comfort.
Designed to move with the reflexes of the wrist, these grips will allow you to jump on the pull-up frame and pump out numerous reps without ripping your hands to shreds. Even if you form blisters, your palms remain protected and will allow you to continue your set. Made from cloth they are designed to withstand sweat, friction from rubbing and won't harden from perspiration.
Give them a go, and become a pull-up expert today!!!
IMPORTANT SIZING INFORMATION
- These grips if sized correctly will fit very firm
- When the palm is extended the grips will stretch too
- The finger holes have been cut small to allow for you to create a perfect incasing around your fingers
- To size, cut with a pair of sharp scissors, cut the hole in an upwards direction leaving the section stitched 1/3 at the bottom. This will avoid OVERSIZING the hole. It will stretch over time.
- You can definitely CHALK them and WEAR them during an entire WOD. They are soft and will not interfere with your performance. DONT WASH REGULARLY, THE DIRTIER THEY ARE THE BETTER!!!
- They will soak up your perspiration and keep your palms reasonably dry during your WOD
- Useful with: PullUps, Toes To Bar, Knees To Elbows, Kettlebell Swings and general barbell work
TIP: ENSURE TO REMOVE ALL HARD CALLUSED SKIN TO ELIMINATE ALL POSSIBILITES OF TEARING
Size - MEASURE FROM YOUR WRIST TO THE BASE OF YOUR MIDDLE FINGER
SMALL - UP TO 4" MEDIUM - 4" TO 4.5" LARGE - 4.5" PLUS
